ASSISTANCE NEEDED

[zozoe]

,,,
Hi all,,I know it's guitar or amp chat, but it's a switch common to guitars & amps...

I just scored a rather pricey microphone very cheap because he couldn't verify that it work. After moving an internal jumper that allows phantom or battery op. BUT, the on/off is worn & to get it to work, I need to find that sole single spot somewhere between on & off. See my pic of the switch, & the 6 contacts beneath the board. I want to jump some wires to the correct points to have the mic ON, forever. The manufacturer even suggests to leave it on when attached to phantom power, & the rechargeable 9v's will always get a trickle, & never drain. So, can I do what I think is possible? It's a simple 2 way switch, but with those 6 contacts.
Thanks in advance for your assistance.

[jeremy]

is the switch just a normal dpdt?

[zozoe]

DPDT,,, found them at Mouser.
thnx

[Top-L]

Get a solder sucker pen. It will make removing that switch much easier.

[zozoe]

My tech will do it for me, cheap, & it's a tight space that I'm not good with. Anything else, I can handle. Parts are on the way!
thnx