Tweet
I bought a Powerstage 170 on Reverb from a big seller. When it arrived I unboxed it and it appeared in good used condition. It came with the power plug, so I took it over to my amp and plugged in the power and my 8ohm cab and Kemper. When I looked at the unit I thought (for a sec) that I saw the “O.C.” light lit, but then I looked again and no lights. I powered it on and from then on nothing is happening. Dead as a doorbell. Is there some way to reset the unit?
-
Last edited by Exodus5; 02-02-2022, 02:08 PM. -
Does it have voltage on the adapter/plug? That is the easy check. I am not sure what is inside of these things.
Edit: Not a big Users Guide either. I think the only tip there is to ensure the Volume is down before powering on.Last edited by JamesPaul; 02-02-2022, 02:30 PM.I miss the 80's (girls) !!!
Seymour Duncans currently in use - In Les Pauls: Custom(b)/Jazz(n), Distortion(b)/Jazz(n), '59(b)/'59(n) w/A4 mag, P-Rails(b)/P-Rails(n); In a Bullet S-3: P-Rails(b)/stock/Vintage Stack Tele(n); In a Dot: Seth Lover(b)/Seth Lover(n); In a Del Mar: Mag Mic; In a Lead II: Custom Shop Fender X-1(b) -
Yep. I’ve verified the cable is good and tried another with no change. I am not about to open this up to check what I can fix, so back she goes….Originally posted by JamesPaul View Post
Comment
-
I'd contact the seller and send it back.Administrator of the SDUGFComment
-
No, the Safety Guide says there is nothing inside to service. I agree with Mincer, send it back DOA.Originally posted by Exodus5 View PostI miss the 80's (girls) !!!
Seymour Duncans currently in use - In Les Pauls: Custom(b)/Jazz(n), Distortion(b)/Jazz(n), '59(b)/'59(n) w/A4 mag, P-Rails(b)/P-Rails(n); In a Bullet S-3: P-Rails(b)/stock/Vintage Stack Tele(n); In a Dot: Seth Lover(b)/Seth Lover(n); In a Del Mar: Mag Mic; In a Lead II: Custom Shop Fender X-1(b)Comment
Comment