Can i Damage My Amp if I plug in two seprate jacks, I have a A/B box i was going to put A output in the High Sensitivity for distortion and the B output in the Low Sensitivity for clean. This is a single channel amp with 2 inputs. Can this be done with out damaging the amp?
Announcement
Collapse
No announcement yet.
Can i Damage My Amp if I
Collapse
X
-
Re: Can i Damage My Amp if I
That doesn't cause any harm to the amp if you do that. But I think one the inputs will only be on if you plug into both inputs on the amp.Last edited by greendy123; 03-20-2006, 10:19 AM.Fender MIM Strat 59 trembucker bridge/Super II neck
Edwards 56' Goldtop 2 x SD P90-1s
Marshall JCM 900 MKIV 2100 slx
Marshall JCM 900 1936 Celestion GT-75/Vintage 30 cab,
Fender Frontman 15g
Cry Baby
Boss DS-2
Boss CE-3
Danelectro Wasabi
-
Re: Can i Damage My Amp if I
It could be a moot point-On some amps, when you plug into the hi side it automatically turns the lo into the hi-or evens out both inputs so if two players are using the same amp, they are at the same level- I don't know about your amp. I guess just try it out!" Rock and Roll IS a contact sport!"
Comment
-
Re: Can i Damage My Amp if I
This doesn't work without mods on some amps...(for example soldano hot rod)
just pull back the guitars volume and the sound is clean, where is the problemRG 550 [JB | SingleSizedHole(TM) | V1 (to be replaced)]
TS 7 (modded)
Hot Rod 50+ XL
Framus Dragon 4x12
V-AMP II for practice
Comment
Comment