I was in Sam ash again with the intent on finding a set of knobs maybe... Maybe a sticker
found this esp on the wall used.... Very abused! It was 330 bucks though!
I talked the guy down to 300.
It's not very worn at all! But someone beat it like a rented mule!
Finish crack, it's been dropped and there are gouges and dents and cracks all over it.
Brought it home, the wiring was absolutely monkey horsecrap wires loose, wires going back and forth... The pickup was busted would only work if you pushed it sideways.... Had a fender in the neck and an sh1 neck in the bridge!
Pulled everything out but the neck pup because who cares about neck pups?! Well maybe some of you guys but not this guy.
Put brand new pots in it, and a Gibson 498t in the bridge, wired it all up correctly.
Cleaned it, found screws to replace all those missing, lem-oiled the board, and stuck some heavy bottom skinny top Ernie balls on it.
Always wanted one of these things. Sounds pretty killer for 3 bills if I say so myself!
All done!
found this esp on the wall used.... Very abused! It was 330 bucks though!
I talked the guy down to 300.
It's not very worn at all! But someone beat it like a rented mule!
Finish crack, it's been dropped and there are gouges and dents and cracks all over it.
Brought it home, the wiring was absolutely monkey horsecrap wires loose, wires going back and forth... The pickup was busted would only work if you pushed it sideways.... Had a fender in the neck and an sh1 neck in the bridge!
Pulled everything out but the neck pup because who cares about neck pups?! Well maybe some of you guys but not this guy.
Put brand new pots in it, and a Gibson 498t in the bridge, wired it all up correctly.
Cleaned it, found screws to replace all those missing, lem-oiled the board, and stuck some heavy bottom skinny top Ernie balls on it.
Always wanted one of these things. Sounds pretty killer for 3 bills if I say so myself!
All done!
Comment