banner

Announcement

Collapse
No announcement yet.

volume, tone pots problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • volume, tone pots problem

    hi after i unsolder and solder the pups back :

    the pots can still rotate even its on "10" if i use some force.

    how can i fix this?
    Fender Strat Special (SH-1n, SSL-1, TB-4)
    Danelectro Fab-tone
    Boss CH-1 Super Chorus
    Digitech Whammy 2
    MXR M-101 PHASE 90
    Dunlop GCB-95 Original Cry Baby Wah

  • #2
    Re: volume, tone pots problem

    or the "knobs"
    Fender Strat Special (SH-1n, SSL-1, TB-4)
    Danelectro Fab-tone
    Boss CH-1 Super Chorus
    Digitech Whammy 2
    MXR M-101 PHASE 90
    Dunlop GCB-95 Original Cry Baby Wah

    Comment


    • #3
      Re: volume, tone pots problem

      If you mean the knobs themselves - are they plastic? If so did you solder with the knobs on the guitar? You could have melted the inside of the knobs a bit so that they no longer bite the pot shaft.

      If it is truly the pot it is just easier to replace them than to open them up and fix unless it is a vintage piece.
      My Bands -
      https://kamikazechoir.hearnow.com/
      www.instagram.com/kamikazechoir
      www.reverbnation.com/theheartlessdevils

      Just some fun guitar stuff from time to time
      GUITAR KULTURE

      Comment


      • #4
        Re: volume, tone pots problem

        thanks wattage...
        but i found out...
        nevermind
        Fender Strat Special (SH-1n, SSL-1, TB-4)
        Danelectro Fab-tone
        Boss CH-1 Super Chorus
        Digitech Whammy 2
        MXR M-101 PHASE 90
        Dunlop GCB-95 Original Cry Baby Wah

        Comment

        Working...
        X