banner

Announcement

Collapse
No announcement yet.

Y cable advice / splitter

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
    Dr. Vegetable
    Mojo's Minions

  • Dr. Vegetable
    replied
    Re: Y cable advice / splitter

    If you're going into two inputs on the same processor, you should be able to use a simple Y cable without noise problems.

    Rule of thumb: Always try the simplest, least expensive solution first.

    Leave a comment:

  • TwilightOdyssey
    Darkness on the edge of Tone

  • TwilightOdyssey
    replied
    Re: Y cable advice / splitter

    Passive splitter should work fine. It's cheap enough to try!

    Leave a comment:

  • evh_slash
    Tone Member

  • evh_slash
    started a topic Y cable advice / splitter

    Y cable advice / splitter

    Heya, I need to run BOTH inputs on my lexicon pcm 80 stereo reverb + fx unit but only have 1 Line out on my amp ... Will a simple Y cable work to split the preamp output into both L/R signals for the lexicon processor, or will this cause Noise/phase cancellation issues etc...
    I aim use this for the "wet" in my Wet/Dry/Wet rig so will there be any problems ?? What If I tried running it serially from my mono FX loop, would the Y cable be ok there too ??

    Or am I better off buying an isolated splitter like a Lehle Line splitter for instance.. ?
Working...
X