Lets see those pedal boards you are using right now.

[Powdered Toast Man]

Here's my current setup:

[Mincer]

This is in my rehearsal studio.

[Demanic]

Using the Super Overdrive to hit the TT Mayhem pedal (which is NOT starved plate btw) From there into the Randall G2 head with 2x12. An old Quadraverb is in the loop of the Randall. The right output goes back into the loop of the Randall head. The left goes into my Behrringer 2X12 combo. A stereo rig with 60 watts and 1x12 per side.

Sent from my SM-A115A using Tapatalk

[maug2122]

Here's mine again .

[GuitarStv]

Here's my current setup:

Man, that's a really nice setup.

[Blille]

Here's mine again .

That’s a lot lol

No labels?

[Powdered Toast Man]

Man, that's a really nice setup.

Thanks! It works very well as a stage rig. I can have everything I need for the set programmed into a bank for effects. Got my vocal processor on the right hand side there. Wireless unit also integrated in. Reverb and Delay linked to the switcher via midi so those two can have specific patches activated with switcher selections. It's complicated to set up but extremely simple to operate during a performance. No more tap dancing on my board.

[Demanic]

Just to disturb Ace.

Sent from my SM-A115A using Tapatalk

[Blille]

Just to disturb Ace.

Sent from my SM-A115A using Tapatalk

You should post it on the other thread

https://forum.seymourduncan.com/forum/the-pedal-board/6048844-let-s-review-those-pedal-boards-you-are-using-right-now/page51

[NegativeEase]

You should post it on the other thread

https://forum.seymourduncan.com/foru...ght-now/page51

I predict a lot of Ace talk about vacuuming.

[Blille]

I predict a lot of Ace talk about vacuuming.

No doubt. The rubber bands may also show up in the review.

[Demanic]

No doubt. The rubber bands may also show up in the review.

Probably.

Sent from my SM-A115A using Tapatalk

[JMP/HBE]

[Securb]

Now that my basement is done, I am putting a pedalboard down there to use with my amps down there. This approximates my old pedal board from the 80's minus an MXR Micro Flange, the MOOG will let me dial in those tones. I got the PedalTrain today, I need to drop by my rehearsal space to get some stuff to wire everything up. I am giddy to hear this with my old Quad Reverb.

[Seashore]

I've had this configuration going for a while. I intended it as a "master board" that would work for recording and both bands I play with. I plug into the Wampler EQ as a first step - mostly as a boost for my basses since I took the preamps out - and then everything else is before the HX Effects. The HX unit has patches set up for 4 cable mode for my guitar rig (VHT Pittbull 100CL) and parallel processing to two separate outputs for my bass rig (Traynor YGL 3 Mark III).

It's neat not having to swap pedals around depending on who I'm jamming with, and it's great having most of the important stuff saved as presets so I don't have to worry about bumping as many knobs by accident when I'm recording. It's also a lot less noisy than my old bass board. But it's still not ideal. I'm thinking of replacing the Wampler with a Source Audio EQ2, so I can have separate presets for basses and guitars. I never wind up using that Maxon OD for anything except goofing around, which is a shame because it's great; really I could probably run my guitar rig with just the HX unit and a tuner, since I'm not using my "real" pedals there anyway. And although I hate admit it, this setup didn't have the bite or mojo that my old bass pedalboard setup did when I finally used it full volume at rehearsal a little while ago. Might be time to get more creative again.