banner

Announcement

Collapse
No announcement yet.

Odd Issue - board can go dead

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
    ThisDyingSoul76
    Toneologist

  • ThisDyingSoul76
    replied
    Re: Odd Issue - board can go dead

    I had a similar thing happen at home a couple days ago. I eventually figured out that one of my unused plugs off my power supply was not wearing it's rubber cap and would move and touch one of the pedals and create a ground loop causing my board to go dead. Found the cap and put it back on the tip and problem was solved.

    Leave a comment:

  • GibStrat_UK
    Junior Member

  • GibStrat_UK
    replied
    Re: Odd Issue - board can go dead

    Thanks guys.
    Well, lots more tests and I think it's a cable - still not sure as the problem won't replicate at will. I'm swapping some out just to be sure and will continue testing.

    Leave a comment:

  • Mincer
    Administrator

  • Mincer
    replied
    Re: Odd Issue - board can go dead

    Does it do this on its own power supply, or in isolation (not plugged into any pedals, just on its own)? How about with a battery?

    Leave a comment:

  • PFDarkside
    of the Forum

  • PFDarkside
    replied
    Re: Odd Issue - board can go dead

    I had the same issue with my board.... It was always the Wampler Pinnacle, it would be dead or reduced signal on a stomp (on or off) and a couple stomp cycles would fix it. Wampler fixed it for free for me...

    Interesting to note, Brian changed to relay based switching since the failure rate of stomp switches is getting so high.

    I'd triple check all your connections (solder joints do fail in patch cables) and stomp switches.

    Leave a comment:

  • GibStrat_UK
    Junior Member

  • GibStrat_UK
    started a topic Odd Issue - board can go dead

    Odd Issue - board can go dead

    Hi,

    I wonder if anyone can help me with an odd pedalboard issue. I posted a photo of my pedalboard in the relevant thread:-
    https://forum.seymourduncan.com/show...52#post4111152

    Every now and then when I select the OCD pedal, the board goes dead. When it happened at a gig I (in panic mode and for want of something better to do) lifted the edge of the board up an inch and dropped it back down and it temporarily solved the problem. At home of course I checked for poor connections but found none, so worked with it until it happened again. It did, after a couple of hours. But this time, for some reason, I switched the Seymour Duncan Vapor Trail delay off and then on, and it cured the problem.

    Maybe that slight movement caused something to make/break, but I'm more inclined to think it might be a signal chain problem - something perhaps amiss in the weird and wonderful of buffers (which I don't profess to understand...) Can anyone more technically au fait than me suggest whether it is a signal/buffer problem?

    Many thanks.
    John
Working...
X