banner

Announcement

Collapse
No announcement yet.

Question about Full Shred and Jackson PS4

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Question about Full Shred and Jackson PS4

    i was just curious if anyone can give me some info on installing a Full Shred bridge pup in a Jackson PS4 with H/S/H. The Jackson pickup(J70?) has a red wire, a white wire, and a bare wire. The Full Shred has 5 wires. Any help would be greatly appreciated. Thanks,Skot.
    Gear: Jackson PS-4 Pro Performer
    Crate GX-130C head
    Hartke 4x12 cabinet

  • #2
    Re: Question about Full Shred and Jackson PS4

    try and find any humbucker wireing schematic with a 5 way switch on the duncan site.
    basically a duncan has a white wire, red wire, black, green and bare. the red and white ones have to be together so it is in full humbucker mode. if you want it split, you have to wire it on the switch.
    black wire is the start of one coild, it goes to the switch, the green and bare ones are the end of the 2nd coil and the ground wire (bare) they go to the back of a pot or a common grounding spot inside the electronics cavity.

    when you wire it, or need any aditional help ( i know i wasnt much at the moment) dont hesitate to ask.. so, when you're done, is it possible for you to take soundclips clean, low gain and high gain of the pup? and post it here or send them to me?
    Last edited by Davey; 12-27-2004, 06:41 PM.

    Comment

    Working...
    X