i have a low end ibanez (model I don't remember) with two single coils and a humbucker in the bridge
i want to replace the humbucker with a duncan humbucker.
now the stock pickup has a wire connecting with the selector and the bare wire
to the volume pot.
the duncan has the red/white/green/black/bare wires.
now i solder the red and whit together and tape.
then solder the black to the selector switch where the stock one was.
now what do i do with the green and bare wire?
the diagram says to ground the green, so i assume i solder it to the back of the volume pot.
right?
thanks
i want to replace the humbucker with a duncan humbucker.
now the stock pickup has a wire connecting with the selector and the bare wire
to the volume pot.
the duncan has the red/white/green/black/bare wires.
now i solder the red and whit together and tape.
then solder the black to the selector switch where the stock one was.
now what do i do with the green and bare wire?
the diagram says to ground the green, so i assume i solder it to the back of the volume pot.
right?
thanks
Comment