HELP with wiring diagram real quick

[j33]

Re: HELP with wiring diagram real quick

kent, my email is [email protected]

if i have to flip the magnet, maybe i should just put a 3way switch in there or some other type of switch.. i think id rather re-wire things than flip the magnet. nothing is simple

[Kent S.]

Re: HELP with wiring diagram real quick

kent, my email is [email protected]

if i have to flip the magnet, maybe i should just put a 3way switch in there or some other type of switch.. i think id rather re-wire things than flip the magnet. nothing is simple

Flipping the magnet is simple, just loosen the bobbins (screws underneath on baseplate); push up the tape enough to get at it, and pull the magnet out and turn it over; then put it back. tighten the bobbins back, and pull the tape back in place. It helps to go in on the side that doesn't have the coil leads attached to the conductor cable; so you don't have to move them out of the way. It gets a bit more complicated with a P-90 or an Invader (with two and three magnets respectively): The process is the same however.
I'll send you the attachment.