Wired it up, kinda cool, but Im curious: how do you do this one CORRECTLY?
1 old JB humbucker, covered
2 unknown singles, non-RWRP, polarity opposite of JB screw coil
Polarity tested via "what attracts the butt end of a Fender single", JB screws attract everything else repels. Humbucker mounted screw side towards singles.
Have (i THINK), from bridge to neck:
[N S] [N] [N]
Wired to colour codes with no regard to phase polarity or humcancel... SHOULD I HAVE??? Any sense in flipping polarity (bar magnets, doable) and wiring for the neck single to get [N S] [N] [S] magnetic and humcancelling on the blended singles? And if I go that route, will it lose its stratiness on the singles?
Disregarding humcancelling, what IS the phasing rule in blending 2 pickups and running that parallel with an unsplit bucker anyway??
1 old JB humbucker, covered
2 unknown singles, non-RWRP, polarity opposite of JB screw coil
Polarity tested via "what attracts the butt end of a Fender single", JB screws attract everything else repels. Humbucker mounted screw side towards singles.
Have (i THINK), from bridge to neck:
[N S] [N] [N]
Wired to colour codes with no regard to phase polarity or humcancel... SHOULD I HAVE??? Any sense in flipping polarity (bar magnets, doable) and wiring for the neck single to get [N S] [N] [S] magnetic and humcancelling on the blended singles? And if I go that route, will it lose its stratiness on the singles?
Disregarding humcancelling, what IS the phasing rule in blending 2 pickups and running that parallel with an unsplit bucker anyway??