banner

Announcement

Collapse
No announcement yet.

Wiring sanity check - HH on a super switch

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Wiring sanity check - HH on a super switch

    I am wiring up my black Strat once again it is going to be a Dimebucker in the bridge and a Bill Lawrence L250 Stacked Humbucker in the neck. One vol no tone. What I would like to do is -

    Bridge
    Bridge - parallel
    Both
    Bridge - split
    Neck

    I can see the wiring in my head I am wondering if anyone has a diagram that is a good jumping-off point.

  • #2
    .

    Comment


    • #3
      Granted I'm not sure about the Bill Lawrence colors... I'm assuming the Bill/Becky 3 wire where white is typically hot and black is ground.

      The only thing that isn't straightforward is the switching. I can't draw anything up right now, but I can attempt to explain it as best I can:

      Jumper the common lugs of Poles 1, 2, and 3, and wire to the volume pot. Connect the common lug of Pole 4 to bridge white.
      Pole 1, Jumper lugs 1, 2, 3, and 4, and connect to bridge black.
      Pole 2, Jumper lugs 3 and 5 and connect to neck white.
      Pole 3, Jumper from Pole 3 Lug 2 to Pole 4 Lug 1.
      Pole 4, Jumper lugs 1 and 3, and connect to bridge red. Jumper lugs 2 and 4 and connect to ground.
      Neck black and bridge green to ground.
      Duncan Pickups in currently in use: '59 (rewound to PATB-3)/'59, Custom/AP2H, Tapped QP set for Tele, Crazy 8/Cool Rails, Screamin' Demon/Stra-Bro 90, Custom 5/Phat Cat, SP90-1/SP90-2, SMB-5D

      Comment

      Working...
      X