Hi guys, I'm new to recording here. Attempting to to dabble in it for the first time this week. Just had some basic questions. First I'll tell you my plan.
Plan:
I bought 2 Seinheiser E609 mics.
I have a 1x12 cab and a 2x12 cab (both from different amps running in stereo). My plan is to drape the mics over the 2 cabinets and have each 1 go to a separate channel on my audient interface.
Questions:
So my main 2 questions are:
#1. Will using a 1x12 cab in conjuction with a 2x12 cab be an issue for recording purposes? Like will it just sound too different that you can't put the 2 signals together in a recording/mix? Any advice is appreciated on that front.
#2. There is a noticeable hum that comes from the speaker as I am using high gain amplifiers. It's nothing crazy, but it is noticeable. How do you guys deal with that when recording? Does it just not carry through the mic well so you don't notice it much, or do you use a noise gate to mitigate it? One thing I was thinking about is I do have a TC sentry noise gate. I could put my guitar directly into that and then go from there into the splitter I suppose. The noise isn't from a pedal or amp I don't think because when I turn the volume down on my guitar it goes away.
Advice appreciated.
Thanks guys
Plan:
I bought 2 Seinheiser E609 mics.
I have a 1x12 cab and a 2x12 cab (both from different amps running in stereo). My plan is to drape the mics over the 2 cabinets and have each 1 go to a separate channel on my audient interface.
Questions:
So my main 2 questions are:
#1. Will using a 1x12 cab in conjuction with a 2x12 cab be an issue for recording purposes? Like will it just sound too different that you can't put the 2 signals together in a recording/mix? Any advice is appreciated on that front.
#2. There is a noticeable hum that comes from the speaker as I am using high gain amplifiers. It's nothing crazy, but it is noticeable. How do you guys deal with that when recording? Does it just not carry through the mic well so you don't notice it much, or do you use a noise gate to mitigate it? One thing I was thinking about is I do have a TC sentry noise gate. I could put my guitar directly into that and then go from there into the splitter I suppose. The noise isn't from a pedal or amp I don't think because when I turn the volume down on my guitar it goes away.
Advice appreciated.
Thanks guys
Comment