Recent content by 60sSoul

Hi-recently somewhere on line I came across a Seymour Duncan low output humbucker neck pickup. People that were using it were raving about it. A few days later I went to order one and now I can’t find it. Can anyone help me?

A while back I bought a pair of 59's which have been ok by I'm thinking of changing them. I was considering a pair of Blues but the description says they are 59's which are wound differently. Is there a big difference in their sound? I play in a Motown/60s Soul group. Open to other suggestions.

I would like to change the speakers in my '77 Twin Reverb. I'd like to replace the originals with Celestion G12 M's. They are 8 ohms like the originals but the watts are not marked on the originals. The G12 M's are 65 watts. Is that a problem?

I would like to wire a 4 wire Humbucker (59 neck) North-Parallel-South. I can find North-Series-South but have had no luck finding N-P-S. Can someone point me in the right direction?

Just purchased a Classic Stack Plus middle pickup and wired it to a push/pull switch to split the coils as per the diagram that came with it. I'm happy with the overall tone but can't say that I find much difference in tone, switch up or switch down. I've gone back and checked the wiring and it...

So I have replaced my stock volume pot (Strat) with a push pull pot. Unfortunately, I did not make a note of which terminal was which. If I lay the pot on the bench in front of me with the shaft up, I know that the tab to the left is the ground. I have found a diagram on line that says the...

I just acquired a 77 Twin Reverb. These amp get a lot of bad press but I'm enjoying it. I would like to get some fuses for it, to have just in case, but the only 4 amp 125 volt slow blow fuses I'm finding are rated 250 and to then to the side in small print, "good for 125" and are ceramic. I...

I have an HSH Strat. I have replaced the Humbuckers with 59s ( which I like very much) and they are both wired with series/split/parallel switches. The middle pickup is a Fender N3. I am obsessing over putting in a in phase/out of phase switch. I was first going to do that on the neck pickup...