Recent content by 80s

Hi all, I was wondering, Someone said to me that the magnet spacing on SD Humbuckers are not ment for Floyd Rose Equipped guitars but only Tradtional Bridged guitars, Is this correct ? Is the alignment any different with a Floyd compared with a Traditional bridge ?

I was wondering, If some nice person could give me a wiring diagram or how to go about wiring 3 hotrails to a 3-way switch. I never use the 2 and 4 positions and would make it easier switching between pickups with a 3-way if I dont intend to use 2,4 pos. 3 hot rails 1 vol 2 tone

Hi all, I think I need a really bassy neck Pickup for my project, I had a body made and the Neck pickup rout is pretty far away from the neck its self (see Pic) I think there will be a lack of bass response. Im looking for something with lots of bass ( i think) and quite a bit of Mids.

Hi all, To cut a long story short, I bought a (22 fret) Jackson about a year and a half ago and It had a SD Distortion in the bridge and sounded really nice and good tone. The Neck pickup was an original Jackson one so I got a SD Jazz for it. I wired everything the way the SD Digram...

Hey all, Ok i have 2 SD Humbuckers in a jackson Randy Rhodes. I get a horrible buzz constant,until I touch the strings. I thought it may be something electrical interfering but I tried my other guitar and that was fine. The jackson has the metal Scratchplate and I used Copper tape to...

Hey all, I was wondering, is it possible to use a DPDT on/on switch rather than using a 3-way selector for a 2 humbucker setup ? Basicly, I never use the middle possition on one of me guitars and would make it alot easier (i think) if i could just select Bridge or Neck. The setup...

Hey all , Got a Laney Cab, dont know sod all about it. Opened it up, Has 4 Celestion speakers named k10t-200 8ohm. Does this mean that each one is 200W ? Also, does this mean that the cab would be 800W overall or 200W ? Also, what Ohm would it be overall ? Any feedback would be...

Hey all ! Got a slight problem with me wiring in one of me guitars, I get a constant hum/ annoying noise like its not grounded and it will go once I touch the strings and re-appear when I remove my hand from the strings. Rather than asking me questions, I have drawn up a wiring diagram so...

Hey all, was wondering if you could point me into the right direction. I have an Ibanez Rg570 with the V7 and V8 pickups in. I installed a hotrail a while ago in the middle position also. I just got me Seymour JB and Jazz and i have installed them. They dont seem as loud as the V7 and V8 pickups...

Hi there, im pretty sure this is the right place to ask this, I want to get some Seymour Duncan for both the neck and the bridge (Humbuckers). I haven't a clue where to start as there's so many to choose from :D. I dont want a Distorted sound really, I prefer Overdrive. I hear High Output...