Recent content by Analoguesolo

I've been looking at various wiring harnesses for Epi LPs that all uses pots that require widening the pot holes to fit the new pots. Is this necessary after Epiphone started to use CTS pots? This would be for a newer Custom or Standard.

I've been considering putting a high output strat pickup like a BKP Trilogy Suite or a SD SSL-3 Hot Strat in the bridge with either BKP Sultans or SD Alnico II Pro pickups in the middle and neck. I need a bit hotter bridge/middle position, The guitar will only have a master volume and a...

I'm planning a HSS Strat, but I want position 2 (North/Top Coil of Bridge Humbucker+middle single) and position 4 (middle+neck singles) to be in series instead of parallel. Is this possible just with a 5-way superswitch (Oak Grigsby).

I know that there are 4-way switches that work with teles, but are there any 4-way slide switches that work with humbuckers. I would have bridge in series, neck inner coil, neck outer coil, neck in series.

I have this recurring idea for a wiring diagram that I keep changing all the time: Now I've revised it again, and I hope someone can draw it for me, please: Position 1, down: BKP Holy Diver in series Position 2, middle:BKP The Mule in series Position 3, top: BKP The Mule split to the top set of...

I've tried to get someone to make a wiring diagram of the following: I'm going to have a Bare Knuckle Holy Diver in the bridge and a Mule in the neck. 1 volume, 1 tone that's only for the Mule, and a 3-way selector that's wired like this: Position 1/Bottom: Holy Diver in series Position...

I have a request for a wiring diagram: It’s going to be a guitar with a Custom in the bridge and a Pearly Gates in the neck, a single volume and a 3-way blade switch. The 3-way is going to be like this: Position 1 (down position): The Custom in series. Position 2 (middle position): The Pearly...