Recent content by Arkitkt

  1. Arkitkt

    Wiring help, please!

    All done! Of course I had the wrong coils of the HR in Pos. 2 and 4 at first, so I had to reverse that. The tiny control cavity if that guitar is a challenge. I also decided to reverse the wiring from the Neck PU to the triple shot because I didn't like the fact that it selected the coil that...
  2. Arkitkt

    Wiring help, please!

    How about this: I'll try it that way and if the 2 and 4 end up not being hum-cancelling, I'll switch them around. Thanks for your help. BTW, you may not remember this, but over 20 years ago ('01, I think) I was searching for a wiring diagram for the first time here and it was actually you...
  3. Arkitkt

    Wiring help, please!

    Could one of the wiring wizards please take a look at this contraption and let me know if it would work? BTW - the sketch is based on one that Mr. Jack_TriPpEr did for me a couple of years ago. All Hail Jack! For background - I have a Steinberger that I use mainly as my travel / rehearsal...
  4. Arkitkt

    P-Rails, SC in Tele - wiring question

    Re: P-Rails, SC in Tele - wiring question OK - the deed is done! The job wasn't completely without its challenges, but it all worked out great in the end: The bad: 1. Regular super switch wouldn't fit into the tele control cavity (too wide). Fortunately we noticed that early enough and ordered...
  5. Arkitkt

    P-Rails, SC in Tele - wiring question

    Hi, Since I'm bored I'm planning to re-do a tele: Is it possible to have a P-Rails (b) and an SC (n) and use only a 5-way for the switcheroo? As in H - P90 - Rail - Rail + SC - SC? I know I could use an additional switch for the P-Rail, but I'd rather have just one switch. TIA
  6. Arkitkt

    The Well CXXIII: Arkitkt - Hard Hat Area

    Re: The Well CXXIII: Arkitkt - Hard Hat Area The body in that picture was not bound. I have since switched it out to a blueburst body from StewMac. In the old, natural one the Bridge mounting studs were in the wrong place and I couldn't intonate it properly. I tried drilling them out and...
  7. Arkitkt

    The Well CXXIII: Arkitkt - Hard Hat Area

    Thanks to Diego for the nomination to host the well (from one beer bearer to another). Have at it - I'll try my best
  8. Arkitkt

    If money didn't matter...

    I'd buy that in a heartbeat: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=290209558541&ssPageName=STRK:MEBI:IT&ih=019 Make sure you check out the video at the bottom of the page. Dude can play!
  9. Arkitkt

    Custom pots??

    Does anyone know where to get pots with unusual values? I'm looking for a triple pot with 10k/10k/500k (all on the same axis) and a double with 47k/500k (also on one axis) and a push-pull. Bonus points for anyone who can guess what they're for. :D Anyone??
  10. Arkitkt

    Guitarport

    Ok - I've been playing guitar for most of my life (over 30 years), but never recorded anything. Time to change that! Yesterday I scored a Guitarport on ebay ($75). I know that some of you guys use that thing. Here's a few questions: - What recording software works well with it (without...
  11. Arkitkt

    Need help identifying PUs

    Hi guys, can someone help identify some Single coil PUs? It's a full set, the middle is RWRP. I was told they came out of a late 80's American Standard Strat, the pole spacing is 2", and they have two bar magnets, one on either side of the poles, staggered poles, they measure at a little over...
Back
Top