Recent content by Burger Boy

On my dual humbucker Ernie Ball Stingray, the output with the SMB-4D in the bridge position is much lower than the SMB-4A in the neck position. Everything is hooked up to a STC-3M4 tone circuit board using a 5 way super switch. Is there someway that I can increase the bridge pup output to...

Hello everyone, I have a copy of a dual pickup Ernie Ball Stingray bass. I installed an SMB-4A in the neck and SMB-4D in the bridge. I have these two pups first going into a 5 way super switch (like the original Stingrays do) and then its going into an STC-3M4 tone circuit board. When...

:)Hello, I'm planning on rewiring a copy of a dual pickup Ernie Ball Stingray bass using either an STC 3M4 or STC 3A tone circuit board. I know that the neck and bridge pickups are wired to the 5 way switch first and then the wiring continues to the volume and tones pots and then down to the...

Hello everyone, I am doing a complete rewiring and replacing of all the electronics for a Ernie Ball Music Man Stingray dual pickup clone bass. I am planning on installing a pair of SMB-4D for the bridge and neck positions. The bass has 4 control knobs on the body. There is also a three way...