Recent content by crull

If the ground wire from a pickup wasnt connected would the pickup still work? Also the pickup has a separate shield wire if that wasn't connected would I notice any hum? Thanks in advance

I rewired my epiphone les paul using a Custom 5 Bridge, and a 59 Neck pickups. All new wire, Jack, switch, CTS pots and .02 orange drops. The tone control wire was normally going to the outside lug on each audio taper pot were the hot wire from each pickup is connected also. I moved the tone...

I recently purchased an Epiphone Les Paul and have been adjusting the truss rod. There wasn't enough relief in the neck so I loosened the rod using an allen wrench. It didn't seem to help all that much and I noticed that the more I loosened it the nut became tighter again. So turning the nut...

I'm hoping someone can help me out here with a few wiring questions. I recently re-wired my Epiphone with (bridge) Custom 5 and (neck) 59. I installed all new CTS audio taper pots, .02 uf orange drops, and a three way switch. I used a star grounding lug in the control cavity, and shielded all...