Recent content by DavidP

Calling all P-Rails wiring gurus... I've searched high & low but can't find a relevant wiring layout to hook up a P-Rails neck and standard tele bridge pickup in the following configuration: #1: bridge only #2: bridge & P-Rails rail in parallel #3: bridge & P-Rails rail in series #4: P-Rails...

Just got a current version Mustang Offset in faded mocha, and find the pickups on the weak side. I'm looking at the Antiquity IIs as a replacement but there's nothing on the spec pages about the neck or bridge being RWRP relative to each other. As I plan to run these in series as well as...

I'm starting to renovate my stock Nashville tele--not a big fan of the Tex-Mex )or whatever they're called) pickups. First item is to put a mini humbucker in the neck; already got the appropriate pickguard so now its deciding on options. I figure a mini humbucker that drops right into the...

Been a while since I've checked in... I have a Godin Session Plus -- great guitar with the GS-2 neck and mid single coils, but the stock bridge HB is pretty thin when split --on the Session Plus there's a 3-way toggle switch to give you each coil as well as full HB. I'm seriously considering...

I've putting a Jerry Donahue in the bridge of my b-bender tele and was thinking of the Vintage Rhythm STR-1 as the matching neck pickup, but can't find anything about this neck pickup being RWRP with the JD... RWRP is kind of critical as I'm using a 4-way switch and want hum-cancelling in the...

In order to address phasing issues, I decided to run a separate bridge plate ground my SD Broadcaster, but it took some time/effort with a 35w iron to get solder to flux and attach the separate lead on the plate (of course I discovered this AFTER I had clipped the lead). I did get it on, pup...

Finally got my tapped pickup for my Esquire and I'd like to wire it as follows with a 4 way Fender switch: low tap w tone/low tap bypassed tone/ high tap w tone/ high tap w bypassed tone. However, I can't find a wiring diagram for this configuration. Anyone done this? Got a diagram?? Thanks!!

I'm planning to swap out the rather anemic sounding bridge pup in my MIM Tele Custom with a SD Broadcaster--are there any phasing/polarity issues I should be concerned about pairing this with the stock Wide Range neck humbucker? Anyone tried this combo in terms of balance?

Anyone tried a Phat Cat vs a 59 for a tele neck position. I'm looking for a fatter sound and reasonable balance with a bridge broadcaster pup.