Recent content by dazzlindino

Is there any way to wire a strat to where only the neck and middle pickup are using a treble bleed? Leaving the bridge pickup unaffected? Trying to stick with the traditional 1 vol 2 tone strat while using a yjm 250K volume pot :help:

On a Strat, what can be done to get 5th fret harmonics with a clean tone?

Looking for a wiring diagram for: Single neck coil and Bridge Humbucker with a 3 way switch 1 Volume 1 Tone Neck single coils sees 250K and goes thru tone 250K Tone just like a typical strat Humbucker sees 500K and does not go thru tone Is this possible? What the heck happened to the Seymour...

Anyone know what difference there is (if any) between an Anico 8 and a Ceramic 8? Same Gauss, tone? Not the large Ceramic, but the small one same size as the Anicos

Have a 2007 Gibson SG with the stock Gibson pickups Bridge reads 7.85 Playing on the bridge pickup, with gain, The wound strings sound fantastic The unwound strings sound extremely trebly and thin What pickup would change this unwound string screech yet keep the wound strings close to it is now

I remember seeing a Duncan Invader in the music store way back, when my buddy was buying a Ibanez Iceman... The one with the original alen screws....but the Duncan timeline says 81....thinking this was late 77 or so.... have also seen where some BC Rich guitars came with them in 78....

looking to wire 2 humbuckers with a 5 way switch wanting: Bridge series Bridge screw single coil (it uses hex screws, just naming it for reference) Bridge slug single coil (it uses hex screws, just naming it for reference) Bridge + neck inner coils, or? Neck series Using Dimarzio evolutions The...

Do unpotted pickups squeal / feedback more than uncovered.... have a covered Seth bridge that's pretty hard to control....

Does any one know of any clips using the stag mag pickup in the bridge split and humbucking?

Have a typical strat with 5 way sw 250 pots putting a hot rail in the bridge position split the pickup sounds best w a 250K pot in humbucking mode it sounds best with a 500K how could one go about this

Have an Ibanez premium 2 humbucker maple cap / basswood body / floyd rose what has anyone found that is a good pickup for this wood combo / configuration both neck and bridge hard rock / metal high gain tones

has anyone used a hot rail in the bridge of a strat then decided to go to a full size humbucker and try to get the same tone? what humbucker would be closest to that?

when he was using his original dimarzio super distortion... was it wired in series or parrallel....

has any one made a hybrid using one coil from a hot rail and one from a cool rail... is there a video showing how this is done?

Anyone know how one could stain a white or parchment pickup to be mint green? Or if any one offers this service?