Recent content by es336td

  1. es336td

    Lil 59ers in a Partscaster... suggestions for rewire

    I built a hardtail Strat from parts I bought off eBay. I put 3 Lil 59ers in it, 2 500K Bourns pots, 1 Gibson 500K push/pull pot, an old 3 way Strat switch and 2 mini toggles. I wired it, like I had done other Strats before, according to an old Jeff Baxter Guitar Player article. Basically, it...
  2. es336td

    One P-Rail?

    I am assembling a mutt. I had an old Truetone Vanguard single pickup body. I bought a nice Strat neck and had an old hardtail Strat bridge and ferrules. Since it only has one route (in the middle), I wanted to add something that would fit the route and give me another nice guitar for slide...
  3. es336td

    Johnson Tele upgrades

    I have an old Johnson Tele... it looks nice (except the goofy headstock), plays nice, and sounds ok... I replaced the useless neck pickup with a GFS blade pickup; slight improvement. I want to now take an old Strat 5-way switch and get something similar to this (1 is all the way towards the...
  4. es336td

    Pearly Gates potted?

    Trying to find a good SD pickup to replace the stock ones in my Epi LP. I am leaning towards PGs but want a potted pickup. The stock Epis sound good to me, but squeal at higher volumes. From the specs, I've found that the SD 59s are potted... just curious.
  5. es336td

    Coil splitting and the Lil 59er..

    I have three Lil 59ers I'm installing in a Strat. I have three switches; two Carvin DPDT mini toggles and one Gibson 500K ohm push/pull DPDT. I want the two Carvin switches to switch the neck and bridge pickups from humbucker to single coil. I want the Gibson to switch the middle pickup the...
  6. es336td

    Tele pickups on a cheap Tele copy

    I have a Johnson Tele... not a monster guitar, but nice enough. I had wanted to put Bardens in a Tele, but don't see the sense in putting $500. worth of pickups in a $150. guitar. Since I know string spacings don't always line up with replacement pickups on these cheaper guitars, I was...
  7. es336td

    Rewiring a Strat

    I have built a Strat from parts on eBay. I have 3 Seymour Duncan Lil 59ers for it, two 500K ohm Bourns linear taper pots, a Gibson 500K ohm push pull pot, a 3 way switch and two mini toggles. I want to wire it as in this article: http://members.aol.com/ludiekunk/temp/JBaxterStrat.jpg, AND use...
Back
Top