Recent content by guitarjunkie986

Hey all, I installed a set of SD Distortions in my Ibanez 7421 about 3 years ago and never had any issues over the first year where I played it pretty heavily. It's been stored in its case in a closet for about a year and a half. I took it out for a rehearsal yesterday and it was pretty much...

Alright, so I took out the stock pickups in an RG7421, and put in a Seymour Duncan Distortion set. I wired it per the following diagram: Every switch position activates the desired coils (confirmed by tapping the pole pieces, but everything sounds way brighter/tinnier than it should. I...

Hi, I'm going to be ordering a set of pickups for my Ibanez RGIT27FE which came with EMG 707's (soapbar size). I am leaning towards a Custom or Custom 5 for the bridge spot, and was curious if it is possible to perform a magnet swap with the active mounted pickups.

Seymour Duncan JB in great condition. Trem spacing. $50 shipped to CONUS PayPal gift

Ok, so I've searched around and I can't seem to find exactly what I'm looking for. Here's what I'd like to do: Liberator (as bridge vol) w/ 2 humbuckers, 2 vol, 5 way super switch. Neck | bridge/neck (inside coils) | neck/bridge | bridge/neck (outside coils) | Bridge. I've found diagrams...

Does anyone else have any issues trying to load the following pages? http://www.seymourduncan.com/products/electric/humbucker/nazgul/ http://www.seymourduncan.com/products/electric/humbucker/sentient/ When I go to either of those pages it is just a blank white page. Those are the only 2...

Mint condition DiMarzio Super Distortion, black coils with silver poles. Has never been soldered or cut. I had it installed briefly using a Liberator pot and it just wasn't a good fit for the guitar. $60 shipped to most locations or would be interested in trading for any of the following...

I installed the Black Winter bridge pickup into my SL2H and I think it's the best pickup I've had in this guitar so far. I originally had the stock JB in the bridge, and switched it out for a TB-5 Custom. The JB had an annoying mid-range honk that I couldn't dial out, and lacked clarity, while...

Hey all, A while back I replaced the stock JB in my Soloist (Maple neck through, Ebony fretboard, Alder body) with a Custom. The JB had an annoying mid-range honk that I couldn't dial out, and lacked clarity, while not being as tight as I would like. I also switched from a Vol/Tone layout to...

Hey everyone, I just received a brand new Schecter SLS C-7 with Blackouts and there is an issue with the bridge pickup. When only the neck pickup is on, everything sounds normal, but when just the bridge pickup is selected or both pickups are selected, there is a loud buzzing/humming sound...

Hey everyone, I have added several pickup demos to my YouTube channel. All were done on the same preset on my ElevenRack so the only variable is the guitar and the pickup. Check them out if you're interested. I have demos of the following: PRS #7 Seymour Duncan Distortion Seymour Duncan...

I'm sure this is a very simple question, and I think I know the answer but I wanted to make sure before I start soldering. I have a Jackson SL2H and am planning on replacing the stock JB with a Custom, swapping out the 250k tone pot for a 500k and making it a volume for the neck, and...

Let me first preface this by saying that I am new to swapping pickups and soldering. I successfully swapped the pickups in a MIM Strat I got recently, in part to practice soldering and gain a basic understanding of things before I tinker with any of my more expensive guitars. Everything went as...