Recent content by Ivan75

Thanks for chiming in Chistofer, I was aiming for 22nF intentionally, I thought the 47nF would not be enough. The cap was placed between the black hot wire of the neck pickup and the switch lug. There it is again, the spot is marked in red. Note the treble bleed is not on the schematic, but it's...

Sorry all for resurrecting an old thread, but this is the only discussion I found that actually tackles some issues. I need some clarification for de-mudding the neck humbucker, but in an HSH configuration where exactly should I put the cap when having a master volume and a master tone which is...

It's an Ibanez RG in questio, HSH, Evos and a True Velvet in the middle. My YM50 5-way switch is gone, I wanted a CRL but I couldn't find one in a short notice. So I wired a Schaller Megaswitch type ''S'' The wiring was standard RG with an additional neck (or bridge) pup splitting using the...

Ok, the guitar in question is '93. Ibanez RG470, so it has Evolutions, neck and bridge with DiMarzio True Velvet RWRP in the middle. The more I think about it, considering some experience, the neck coil split just won't cut it. What I aim for is HSS configuration with neck and middle singles...

Re: Push-pull volume pot with treble bleed on coil split problem Ok, what I thought, exactly, works in split or full humbucker. This is the treble bleed circuit I mentioned: Two points are soldered to volume pot lugs. Little pot with cross allows regulating the amount of highs which pass.

Hi everyone, I'm about to start a project on my Japanese '93. RG 470. The stock pickups were changed to Evolution neck and bridge with True Velvet single coil. Now I have ordered the V-Treb treble bleed circuit for it, and I want to split the neck pickup using the 500k push-pull pot on volume...