Recent content by iYOAK556

Figured it out. Started checking DCR and all that and on the surface everything was as it should be. Then I noticed the hot wire looked odd. Apparently when I stripped the wire shielding, I had my strippers set too low and took off some wire strands. Basically made the wire half the gauge it...

Standard SD wires. Red/white soldered together, green/bare to the ground and black to the top lug like in the photo. It’s possible the red/white came unsoldered under the heat shrink I have on them but that’s unlikely. Worth checking again I suppose.

So I’m wiring a project with a George Lynch Kamikaze setup, one push/push pot to control volume and pickup selection. It’s wired as per the diagrams I can find, however my bridge pickup(SD Jupiter) is split and is now essentially a single coil. That is not the intended result. I don’t have a...