Recent content by jdean

I,m a little uneducated in this area so I could use some advice. I,ve got a '75 ric 4001 that I put replacement V63 p/u's and complete harness in ,I just had to have the bridge p/u rewound, when it came back the resistance read 15.4k, the untouched neck "toaster p/u reads 11.9k, pretty hot,I'd...

Just installed a set of pearly gates in my Explorer. Also CTS DP/DT push/pull volumes with single master tone .wiring DP/DT volumes. for series/parallel.following the SD wiring diagram.The neck p/u works perfectly, however I,m not getting anything from the bridge P/U. (barely hear it).if at...

I just bought a set of Seymour Duncan pearly gates humbuckers for my Explorer, Im in the middle of wiring it using their schematic ; 2 push pull volumes/1 tone/3 way toggle. "series/parallel" instead of a coil cut. But even with a coil cut would it make a difference soldering on the nickle...