Recent content by madaxeman

Can anyone tell where I can buy the shielding or grounding base plate that sits at the bottom of a les paul's cavity? The plate that houses the pots. Looked on ebay and all over the net. Just need the plate minus the pots.

neck pickup dead no sound on a les paul. any ideas?

Why does my volume pot work fine until I get to 10 then it cuts out? Guitar is a gibson les Paul.

Can I use a 500k linear pot in the tone pot position? are they the same? Or do they make specific pots just for the tone position?

My neck pickup is dead when the toggle is in it's position but fine in the bridge position. Would this be a dead dead pot or a 1/2 dead toggle switch? How can I figure out which it is without guessing?

Can anyone recommend a luthier in the states to refret some old Les pauls I own. Seek sweet work with fair prices.

Can anyone tell me what the stock pickups were in a 1982 Les Paul Silverburst?

Suggestions, Looking for a Pup to blend nice with a 59 in the bridge of a Les Paul. Not too bassy not to much trebble . A nice chimey tone if possible. But real blusey when cranked.

Can the ssl-4 bridge pup be used in all positions. Or do they make a specific ssl-4 wound for neck and middle?

When my volume pot is at it's maxed off position my guitar can still be heard as if it were on one. I checked all the wiring removed the volume nob ect. can anyone tell me what's causing this? And how to repair the problem?

Can anyone offer the wiring schematics on a blackmore strat setup?

The strat I am putting together has the Blackmore pup configuration. single coil bridge single neck 3 way toggle. I have been looking into the APS- 2 RW/­RP for my neck position pup. Is it wise to go with a reverse polarity pup for this type of setup?

Have a strat with a ssl-4 in the bridge. Been looking into the APS-1 Alnico II for the neck position. Can anyone share there experiences with this pup? Any other neck pup suggestions to blend with the ssl-4?

Is there much tonal difference between staggered and flat pole pieces?

Looked all over the web including Duncans site. Looking for a diagram of this specific wiring. 1- humbucker bridge 1- single coil neck 1 volume no tone 3 way toggle switch. Can anybody help?