Recent content by markster65

Thanks for all your help. Here's what the issue was: When I ordered a new 3 way from Allparts they were out of the CRL's so I ordered an Oak Grigsby. The lugs are laid out a little different. I took the switch out of the guitar and compared to my tele with a crl and bingo. Thanks again All...

just 0.0 in middle position.

Thanks for your help ehdwuld. The jumpers have continuity. between A1 and A2 also between B2 and B3. Bridge position i'm getting 9.95K at cable end Neck position I'm getting 7.1K at cable end I get no reading on middle position at cable end. The wire used is all cloth push back and the...

I just noticed, everything works great but no sound in middle position. Do I need a a jumper on the A2 to the B2? (It seems redundant but what else could it be?)

Appreciate all your help! I'm going to clean up the soldering, shielding, and rewire everything. ehdwuld, this is based off your original diagram. Everything look ok?

Thanks for the diagram. I'm doing some fret work and installing a kill switch on my buddies guitar. When I popped the control cover off, the wiring seemed odd. Here's his current wiring. Does this look normal? It looks like I need to remove the A2 to B2 jumper on the 3 way and fix the tone pot...

I need a wiring diagram for 2-humbuckers (braided wire), 2-volumes, 1-tone, and a 3-way blade switch. Any help would be appreciated

My Nitro has dried and I'm ready to start wiring. Below is the updated schematic. Does everything look ok?

I based it in the below wiring diagram. So this wont work? I just want position 1 bridge humbucker, position 2 split humbucker north coil and SC neck, position 3 SC neck only.

Will this wiring work with a JB bridge and a SSL-6 neck? (I've read the SSL-6 in the neck works better with a 500K pot. If that's the case I'd just leave the resistor off.) The guitar is a chambered swamp ash body with a 24.75 conversion neck. If you have a better pickup combo recommendation I'd...