Recent content by Mike M

I found this, searching the internet, but in this diagram, they are using 2 mini-toggle switches instead of push/pull pots. Maybe this picture will help show you what I am wanting.

Hello! Does anyone have a wiring schematic for a Strat-style guitar, using 2 P-Rails, 2 Volumes, 1 master tone, 3-way lever switch? The 2-volume pots would be the Push-Pull's to get the single coil, P-90, and Parallel switching. Any help is appreciated! Thanks

I have a 1966 Non reverse Firebird V. It has 2 mini hums on a slider switch. Can anyone help me find the wiring diagram for this model and year? Google has come up with nothing. Thanks!!!

I am looking for a wiring diagram to wire 3 P-90's to a 6 way rotary switch. Nothing special just -Neck -Neck and Bridge -Neck and Middle -Middle -Middle and Bridge -Bridge I am going to use the 6 way rotary that stew Mac sells. Not sure if I need a 2 pole or 4 pole for this? If anyone has...

Ok, so I have an older Jazz neck pickup and recently bought newer bridge Jazz for my guitar. Wired it in the typical Les Paul fashion. All worked except the middle position was out of phase. The bridge and neck were fine by themselves. I thought the neck was the culprit, so I shrink tubed...

The black rings that came with my SD Seth's fit perfectly, but are curved bottom. I need flat. The flat rings I have have gaps inside of the ring like they are too big. Any way to find the correct rings for SD's that fit as well as the ones that SD ships with? Thanks

I have a 335 style guitar I am building. I love my Antiquities, but on this guitar, I want to have coil splitting. Any recs for this pickup? I have Fralin Unbuckers, that I love, but want the great HB tone of the Antiquitiy but that can have great single coil tones. Thanks

Chrome covered humbucker in the bridge position and has a sticker underneath that says "DC". Any ideas? Thanks

Hello. I was hoping that someone could help me with a guitar that i am building. The guitar will have 3 p-90's and I want to put them on a 5 way rotary switch. So all 5 combos will work like a strat. Anyone have any schematics for this? all I can find is PRS schematics for 2 humbucker...

I am building a custom guitar made of Mahogany and rosewood neck. The body will be mahogany as well. Which humbucker for the neck position will have a brighter tone to balance the warmer wood? Also, which single coil bridge pickup will work with the above humbucker in the neck. I thought the...

Hello, I just finished a guitar project last night and after installing the electronic I noticed that there are issues with my neck pickup. I am unsure if it is a bad pot or pickup. The pickup is a 59 Neck pickup. The bridge is a CS model of some sort. The bridge only position sounds fine...

I have a SD pickup that is 2 conductor and has a sicker that says 59 NJ. What model is this and what would be the best match for it? Is this a very good model? I really like humbuckers to have a brighter tone. Thanks

Okay, this is my first post so I will make it good. I have three tele style guitars that I made. These were some of the first ones I had built and I had little knowledge at the time about choosing the wood and matching the pickups. I just made them and stuck in pickups I thought would sound...