Recent content by poit57

I recently installed the SPB-2 pickup on my bass. I was confused when I installed the new pickup because the old pickup was permanently attached to the housing with the mounting "ears" to put the screw through. This allowed springs to be installed for better height adjustment. With the Seymour...

I'm thinking about working on this DIY bass guitar kit http://diyguitarkits.net/jb.htm. It is listed as a Jazz bass, but it is actually laid out like a Active Deluxe Precision with a MM-style pickup replacing the J-style bridge pickup. My reasoning behind getting the kit is because I would like...

About 5 years ago, I assembled a bass guitar with parts from Warmoth.com and I used a Basslines MM style pickup. Then about 6 months ago, I replaced the stock pickups and electronics on a low end Rogue 6 string bass with ASB2-6 pickups and STC-3 active electronics. Both of these sets came with...

I just replaced the pickups on my 6 string Rogue LX406 bass with a set of ASB-6's and STC-3 electronics. The configuration of the pots that came pre-wired for the electronics (stacked bass/treble pots) did not work for the way my guitar was set up, so I completely rewired the electronics with...

I purchased a Rogue LX-406 a few years ago and decided to try to replace the pickups and electronics. I just finished wiring up a set of ASB-6 pickups and STC-3 electronics. This setup includes the following knobs: Volume, blend, treble, mid and bass. After I was finished and went to test my...