Recent content by prismatic67

I have for sale a SD SSL-3 strat pickup. It's hot and it's mean. It has like a thick, saucy gilmour-esque tone in my Ash/maple strat. Almost had a les paul sort of vibe (think Jimmy Page) when I first tested it in my buddy's alder/rosewood strat. I have since installed a Seth Lover in my strat...

These are the real deal if you are after accurate P90 tone, as good as you can get! Alnico II, not-potted, and smooth as butter- comes with both black and cream covers. I traded my P90 LP without the pickups, for a lighter, humbucker routed LP also without the pickups- so trades are definitely...

I'm getting rid of some strat parts to put the money into my P90 lester :33: All are going very cheap, first come first serve! Seymour Duncan SSL-5 (normal wind), pretty much brand new but with moderately short leads. (includes mounting hardware + original white cover) - only $30 shipped...

Re: Strat.. 2 Volumes, 1 tone - Would this work? Like this? I am not concerned if the signal bleeds through when the pot's at zero, as the switch will prevent it. Oh and I know the tone control looks like it's wired backwards, but it actually works normally. Wiring it normally causes it to...

Well, I plan to wire my strat back to 3 single coils, humbucker tone is just not for me.. haha Anyway, I do like having separate volume controls- in this case a volume for the neck alone, a volume for the bridge + middle, and a master tone. I initially though I'd need one of those...

Hi all, I have for sale on eBay an SSL-1 Vintage Staggered strat pickup; it was originally in my strat's bridge position, being replaced by a Seth Lover Trembucker. Sounds sweet, but I was desiring a vintage-output humbucker instead. It is in good condition and works perfectly; tested to...

Hi everyone, I am new here... I am planning on wiring up my newly acquired Seth Lover trembucker (TB-55) in the bridge, along with a single coil in the neck. I am choosing to leave out the middle pickup since it hardly gets any use + gets in the way. I plan to have a 3-way switch, as well as...