Recent content by rebel082002

i swear i have spent the last hour & half tring to find a tread with the info. I need and I'm sure it's out there but I just cant sewm to find it. What i want is a diagram/ picture of the wiring for a Schaller MegaSwitch E+ Model for my tele mod which has a Humbucker (SD lil'59) in the bridge...

If you look at all the stuff on the SD site it seems they pair hums that have the same type of magnet. Like the cust cust sh 11 and and aph 2 pro and I understand that. But what are the other considerations. Like is there a chance a sh11 would sound good with a 59 or even a phat cat? Just...

If you look at all the stuff on the SD site it seems they pair hums that have the same type of magnet. Like the cust cust sh 11 and and aph 2 pro and I understand that. But what are the other considerations. Like is there a chance a sh11 would sound good with a 59 or even a phat cat? Just...

I am doing a custom build withheld with a rio grande bridge and a phat cat in the neck. I used 2. 375k Alpha pots and NOS .033uf cap with .001uf treble bleed. My is i get no sound until the volume knob hits 6, then in sounds great. What in the world could cause this? All connections and...

Is there a reason that Seymour Duncan does not have a wiring diagram for a setup with 2 phat cats 1 vol, 1 tone and 3way toggle pickup selector switch. I really need this diagram. I am putting a pair of phat cats in a PRS Singlecut hollow body II. It has master tone, master vol, 3 way switch...

Can someone give me a difinitive answer as to what the specific hole spacings are for the SD Custom Custom Bridge and the Alnico 2 Pro "Slash" Model. I bought a couple of these used and they are zebra's so I was going to put some covers on them. Well one guy said use 1 31/32" hole spacing...

SD Phat Cat question If you use a traditional PU selector switch is the bridge pick still hum canceling when only it is selected? If not how would you wire it so that it is? Could you use Pan/Balance pot instead of PU selector switch, so that both remain on to some degree...

I am swapping out the pickups in my PRS hollow body and want to to go a little different route than the Gibson 57 plus's or SD 59‘s I usually play. I want to get my distortion from my amp not my pu so the guitar will be a little more versatile. I love the SD custom P90 tone if they would work...

I am still working on my Project HSH but have focus to the middle pu. It's a Fender Hot alinco 3 Reverse wound/Reverse Polarity. Issue: Do not have H/H with current wiring, Mid is always on. Can you use a Push/Pull (DPDT or SPDT) pot to turn the middle pu on & off, no matter the switch...

OK I have been looking for an hour and I have found 500000000000, wiring mods, but all i want is to use a typical 3-way switch and a pickup selector in a Hum/single/Hum pickup configuration. Switch Position Up - H/S Mid - H/H Down - H/S/H I just want it to activate the pickup's like...

I put a SD Lil' 59 in the bridge position of my tele and a full size 1959 HB in the neck. I wired the Lil' 59 to a 3-way toggle switch just like the SD wiring diagram shows, I think. The problem is that the switch seems to work, I get 3separate distinctive tones with a hotter series tone, but...