Recent content by shaddart

I did this on a couple electric banjos, (one P-Rail, one Cool Rail. the diagrams I found on this site were confusing to me, ok maybe I’m a little bit dyslexic, ha ha. In the most trusted legitimate diagram I found here ( by Hermetico) the two pots were illustrated as inverted from each other...

I used foam rubber from some kind of packaging and I put the nuts on top, just because I could, but I’m sure most people would use wood screws.

Edit: I wired it up and tested it - works as it should: both down= series, both up = parallel, one up, one down= split (single) Well, it’s been a while, I installed the P-rails a while ago, and I’m about to install a Cool Rails pickup on another electric banjo, someone wanted to see a...