Re: Two humbuckers in series with each other?
Okay, let me see if I've got this right:
I searched the forums and from what I can tell, on a normal 3-way the two comon lugs are at the top right and bottom left of the switch, as you look at it from below with 'top' being towards the neck.
So, using SD wiring colours:
The black wire from the bridge pickup (bridge hot) goes to pole 1 lug 1. Pole 1 lug 2 is connected to pole 1 lug 1.
The black wire form the neck pickup (neck hot) goes to pole 1 lug 3. Pole 2 lug 2 is connected to pole 1 lug 3.
Pole 1 lug C goes to the hot outpot tab of the volume pot.
Pole 2 lug 1 goes to the back of the volume pot (to ground). Pole 2 lug 3 is connected to pole 2 lug 1.
Now one bit I'm not sure on. The bridge ground goes to pole 2 lug C - would that be the green wire or the bare wire? As I understand it normally, black is hot, red and white get taped together (series link), both green and the bare wires go to ground. So in this wiring, would both the green and bare wires go to P2.C, or just one?
Okay, let me see if I've got this right:
I searched the forums and from what I can tell, on a normal 3-way the two comon lugs are at the top right and bottom left of the switch, as you look at it from below with 'top' being towards the neck.
So, using SD wiring colours:
The black wire from the bridge pickup (bridge hot) goes to pole 1 lug 1. Pole 1 lug 2 is connected to pole 1 lug 1.
The black wire form the neck pickup (neck hot) goes to pole 1 lug 3. Pole 2 lug 2 is connected to pole 1 lug 3.
Pole 1 lug C goes to the hot outpot tab of the volume pot.
Pole 2 lug 1 goes to the back of the volume pot (to ground). Pole 2 lug 3 is connected to pole 2 lug 1.
Now one bit I'm not sure on. The bridge ground goes to pole 2 lug C - would that be the green wire or the bare wire? As I understand it normally, black is hot, red and white get taped together (series link), both green and the bare wires go to ground. So in this wiring, would both the green and bare wires go to P2.C, or just one?
Comment