The most simple reverb pedal schematic?

[USAPatriot]

Re: The most simple reverb pedal schematic?

This one and anything that you can stomp on and clicks:

That reverb has definitely stood the test of time! -Rod-

[NecroPolo]

Re: The most simple reverb pedal schematic?

That reverb has definitely stood the test of time! -Rod-

It is made for the eternity due to its well-thought design and components. The company did not cut corners on development time.

There are some downsides, though. It may be problematic to carry and it needs an XXXXXL pedalboard. It is said to be a one-trick pony because of its limited controls, the seemingly simple users interface may be confusing at first. Plus, I have read mixed vievs about the company itself, it is almost impossible to sell and I miss true bypass. But it may be solved to add any pedal in the chain that has true bypass. There is still no substitute or decent modeling for the sound of a signal going from A to B through a bare wire without electric components

[rumblebox]

Re: The most simple reverb pedal schematic?

You guys have way too much time on your hands. hahaha

[zzmoore]

Re: The most simple reverb pedal schematic?

ok here's what i'm doing. i'm building this circuit on a perf board and adding a low pass filter for the reverb effect.

so basically i'm replacing the 100k resistor with a 100k pot and a cap. which cap should i use on that pot? a .22? .1? .047??

http://www.modkitsdiy.com/sites/defa...structions.pdf

They did a great job with their PDF.
Go for it and Good Luck.

[rumblebox]

Re: The most simple reverb pedal schematic?

I'm also thinking about installing both medium and long reverb modules with a 3pdt footswitch or mini-toggle.