Hot Rails wiring for classic player series Jaguar

[Novamute]

This is my first post here, so I'll just get right to it. I have a Hot Rails pickup that I'd like to use to replace the stock bridge pickup on my Jaguar. I've been having trouble finding information on how exactly to do this. If possible, I'd like to put on some sort of switch so I could play the Hot Rails pickup as humbucker or split coil. Thanks in advance!

[GuitarDoc]

Welcome to the forum.

Assuming you have a classic Jag, here is the basic wiring diagram...
http://www.seymourduncan.com/support...hematic=jaguar

Here is a diagram that shows how you will replace the bridge pup with any humbucker pup (inc Hot Rails) that has typical SD 4 cond. wires. The diagram shows the use of a push/pull pot, but any 2P2T mini toggle will work and be wired just the same...
http://www.seymourduncan.com/support...ol_1tone_split

[Novamute]

Thanks man! It's classic player series, which is the newer ones, but after opening it up and looking at it, there's not too much difference in the wiring. This definitely helps a lot, so thank you!

[Demina]

That SD diagram for the Jaguar is not completely accurate for the 62 AVRI, 50th anniversary, MIJ SE, Squier VM, and original 62 Jaguars, and I bet your CP is the same as the ones I listed and likely the new 65 AVRI as well. The differences are that there should be a 56K ohm resistor on the lower tone control, and the capacitor on the upper tone should be .01mfd rather than .1. This does not apply to the Squier VM HH, Fender Blacktop or Fender Modern Player models.