Y cable advice / splitter

[evh_slash]

Heya, I need to run BOTH inputs on my lexicon pcm 80 stereo reverb + fx unit but only have 1 Line out on my amp ... Will a simple Y cable work to split the preamp output into both L/R signals for the lexicon processor, or will this cause Noise/phase cancellation issues etc...
I aim use this for the "wet" in my Wet/Dry/Wet rig so will there be any problems ?? What If I tried running it serially from my mono FX loop, would the Y cable be ok there too ??

Or am I better off buying an isolated splitter like a Lehle Line splitter for instance.. ?

[TwilightOdyssey]

Re: Y cable advice / splitter

Passive splitter should work fine. It's cheap enough to try!

[Dr. Vegetable]

Re: Y cable advice / splitter

If you're going into two inputs on the same processor, you should be able to use a simple Y cable without noise problems.

Rule of thumb: Always try the simplest, least expensive solution first.