Good day,
I want to be able to put my drive pedals in and out of what's going to my amp's front along with an EQ pedal with a switch.
Problem is the amp only has one mono input. An AB switch will let me go between the the two drives and the EQ on opposite AB, but the problem is the output for those. Since the amp has only a single input how do I put the two outputs of the two front "loops" I guess to the single input of the amp?
Basically...
Position A:
... -> EQ -> Amp Front
Position B:
... -> Drives -> Amp Front (no EQ Pedal)
Would something like this solve my problem (it can work both ways)? Seems like when the EQ is engaged, the drives would still be active, introducing unwanted noise into my signal.
Note this is NOT the effects loop, just the amp front.
Thanks,
GreatOz
I want to be able to put my drive pedals in and out of what's going to my amp's front along with an EQ pedal with a switch.
Problem is the amp only has one mono input. An AB switch will let me go between the the two drives and the EQ on opposite AB, but the problem is the output for those. Since the amp has only a single input how do I put the two outputs of the two front "loops" I guess to the single input of the amp?
Basically...
Position A:
... -> EQ -> Amp Front
Position B:
... -> Drives -> Amp Front (no EQ Pedal)
Would something like this solve my problem (it can work both ways)? Seems like when the EQ is engaged, the drives would still be active, introducing unwanted noise into my signal.
Note this is NOT the effects loop, just the amp front.
Thanks,
GreatOz
Comment