Announcement
Collapse
No announcement yet.
Mustang project?
Collapse
X
-
Comment
-
-
Re: Mustang project?
You should replace the screws on that bridge pickup, they're getting kinda grubby looking.Join me in the fight against muscular atrophy!
Originally posted by Douglas AdamsThis planet has - or rather had - a problem, which was this: most of the people living on it were unhappy for pretty much of the time. Many solutions were suggested for this problem, but most of these were largely concerned with the movements of small green pieces of paper, which is odd because on the whole it wasn't the small green pieces of paper that were unhappy.
Comment
-
Re: Mustang project?
Noone will probably reply but I'll ask: How do you reckon I should wire the mustang to split to the south top coil and be in phase with the JB? I'm wiring the JB stock. Black to hot, green to ground, and the red will split it to the north slug coil. I would probably be able to figure it out, but I forgot to note which colors were the start and finish when I was assembling it. And all the diagrams I see are all goofy and I can't tell from them either.
Last edited by Clint 55; 03-13-2020, 10:02 PM.The things that you wanted
I bought them for you
Comment
-
Re: Mustang project?
Thx for chiming in. I wrote all the details in post 69. Picture is post 66. I didn't change the leads at all on the Mustang stag mag, just stuck them on an hb baseplate. Let me know if you need more details. If you could just tell me which leads are the start and finish, that would be helpful.The things that you wanted
I bought them for you
Comment
-
Re: Mustang project?
what are the wires colors on the mustang pups? usually start would go to ground and finish would be hot. yellow and blue or ? you didnt answer my question and it isnt in the posts you listed. there are two mustang pups, which pup is where? neck model towards the neck or towards the bridge?
Comment
-
Re: Mustang project?
The orientation of a humbucker makes no difference to its phase relationship with itself or the other pup. Just magnetic and electrical polarity. But the south bridge mustang is going to be on the top and the north neck mustang is going to be on the bottom. The neck mustang has a yellow and blue lead, and the bridge mustang has a white (parchment) and blue lead. I'm thinking about wiring the mustang how I wrote in post 70 and diagrammed in post 69 but I don't know which leads are the start and finish on the mustangs.Last edited by Clint 55; 03-15-2020, 11:50 AM.The things that you wanted
I bought them for you
Comment
Comment