Hello all,
It's been a while since I've posted here since I haven't touched my axe in 5 years or so
So I finally had the urge to pick it back up and fired up my good old Engl Powerball.
But to my disappointment no sound was produced when I switched it to channel II (Hi gain).
Channel I sounds fine on both clean and crunch but when I switch to channel II I only hear a hum (both on lo and hi gain).
Switching to master 2 doesn't make a difference.
One of the preamp bulbs does light up a bit less bright.
Could it be that the preamp bulbs need to be replaced or might I be looking at bigger issues?
Thank you for the help!
It's been a while since I've posted here since I haven't touched my axe in 5 years or so
So I finally had the urge to pick it back up and fired up my good old Engl Powerball.
But to my disappointment no sound was produced when I switched it to channel II (Hi gain).
Channel I sounds fine on both clean and crunch but when I switch to channel II I only hear a hum (both on lo and hi gain).
Switching to master 2 doesn't make a difference.
One of the preamp bulbs does light up a bit less bright.
Could it be that the preamp bulbs need to be replaced or might I be looking at bigger issues?
Thank you for the help!
Comment