Hi All,
I am in the process of building an oil can guitar (will post some pics later) and wanted some advice on pickup wiring, for the following configuration:
Single Humbucker (P-Rail Bridge)
3 Way Blade (North/Parallel/South)
1 Vol
1 Tone (Series Pull)
I have found a wiring diagram for this config with x2 single coils (Tele setup), but wanted to make sure it would work with the P-Rail.
If I'm right (which I'm probably not), the Tele Neck pickup would be replaced with the Black (North Start) and White (North Finish) wires and the Tele Bridge with the Green (South Start) & Red (South Finish), with the bare wire connected to the Green(?)
I would be extremely grateful for your advice and (ideally) wiring diagram.
Please Note: My 3 Way blade is a cheapo aftermarket version with the lugs numbered 1-8 in a line along the one side.
Many Thanks
I am in the process of building an oil can guitar (will post some pics later) and wanted some advice on pickup wiring, for the following configuration:
Single Humbucker (P-Rail Bridge)
3 Way Blade (North/Parallel/South)
1 Vol
1 Tone (Series Pull)
I have found a wiring diagram for this config with x2 single coils (Tele setup), but wanted to make sure it would work with the P-Rail.
If I'm right (which I'm probably not), the Tele Neck pickup would be replaced with the Black (North Start) and White (North Finish) wires and the Tele Bridge with the Green (South Start) & Red (South Finish), with the bare wire connected to the Green(?)
I would be extremely grateful for your advice and (ideally) wiring diagram.
Please Note: My 3 Way blade is a cheapo aftermarket version with the lugs numbered 1-8 in a line along the one side.
Many Thanks
Comment