Hi,
This will be my first attempt to re wire a new guitar from actives (EMG81/85) to passives (JB/59 or JB/Sentient). I was thinking about doing the 5 blade wiring to have the coil split option. I may not use them if they hum too much but I thought since I am rewiring the whole thing I might as well giving them a try.
Where is the ground wire coming from the bridge in this diagram though? Even my factory installed EMGs have them going to the pot. I don't see it in this diagram. Should I run a ground from the bridge to the tone pot anyway? The 3 blade switch diagram shows the bridge wire going to the tone pot, for some reason this one (5 blade/split coil) doesn't.
Also, I'm looking at the switch from the bottom part, right?
Thank you!!
2 HUMBUCKER | 1 VOLUME
1 TONE | 5 WAY BLADE (with coil split)
This will be my first attempt to re wire a new guitar from actives (EMG81/85) to passives (JB/59 or JB/Sentient). I was thinking about doing the 5 blade wiring to have the coil split option. I may not use them if they hum too much but I thought since I am rewiring the whole thing I might as well giving them a try.
Where is the ground wire coming from the bridge in this diagram though? Even my factory installed EMGs have them going to the pot. I don't see it in this diagram. Should I run a ground from the bridge to the tone pot anyway? The 3 blade switch diagram shows the bridge wire going to the tone pot, for some reason this one (5 blade/split coil) doesn't.
Also, I'm looking at the switch from the bottom part, right?
Thank you!!
2 HUMBUCKER | 1 VOLUME
1 TONE | 5 WAY BLADE (with coil split)
Comment