I get a lot of electrical noise in my house, so I decided to shield my Warwick today. Took out the pickups and knobs, lined all with aluminum foil, and grounded each cavity. All the noise is 100% gone whether I'm touching the strings or not. This was the cheapest and easiest mod I've ever done, and yielded the most night & day results. Go figure.
Announcement
Collapse
No announcement yet.
Aluminum shielding
Collapse
X
-
-
Re: Aluminum shielding
Warwicks have a pair of large springs under each pickup. I put the end of a ground wire underneath a spring in each pickup cavity, then soldered the other ends to the tone pot. For the control cavity, the pots are in direct contact with the foil.“I can play the hell out of a riff. The rest of it’s all bulls**t anyway,” Gary Holt
Comment
-
Re: Aluminum shielding
Does aluminum cause any bleed of higher frequencies due to Eddie currents? (I know it's probably much less of a problem with a bass than an electric guitar.)Join me in the fight against muscular atrophy!
Originally posted by Douglas AdamsThis planet has - or rather had - a problem, which was this: most of the people living on it were unhappy for pretty much of the time. Many solutions were suggested for this problem, but most of these were largely concerned with the movements of small green pieces of paper, which is odd because on the whole it wasn't the small green pieces of paper that were unhappy.
Comment
Comment