So I bought my self an older Fender Champ lap steel clone.
It had the originals a older set of Guyatone pickups in it.
It is a 2 Pick model with the bridge slanted like a Strat.
I have a SD JB-JR Strat bridge pup.
Pretty sure I am going to order the JB-JR Neck to go with it.
I am going to replace the pots in it as well, came with a 100k Tone pot and 500k volume pot with a .020mF - 50VDC CAP.
Is there any advantage to keeping the Volume pot a 500k and using a 250k tone pot? Or should I just go 250k for both?
I would think a .047mF 200VDC Cap would be an improvement.
Anyone think there there is a good advantage with a treble bleed kit or the grease bucket kit in this application.
Any suggestions of ideas are greatly appreciated.
Thanks D
It had the originals a older set of Guyatone pickups in it.
It is a 2 Pick model with the bridge slanted like a Strat.
I have a SD JB-JR Strat bridge pup.
Pretty sure I am going to order the JB-JR Neck to go with it.
I am going to replace the pots in it as well, came with a 100k Tone pot and 500k volume pot with a .020mF - 50VDC CAP.
Is there any advantage to keeping the Volume pot a 500k and using a 250k tone pot? Or should I just go 250k for both?
I would think a .047mF 200VDC Cap would be an improvement.
Anyone think there there is a good advantage with a treble bleed kit or the grease bucket kit in this application.
Any suggestions of ideas are greatly appreciated.
Thanks D
Comment