Hey y'all!
I've been looking for an answer for this for a bit, so I apologize if this has already been covered in another thread that I could not seem to find. I am just beginning with pedal building so there is a lot to learn and understand!
I cut the brown wires coming from S1C to get the rate indicator LED to be always on and ready for a tap. I don't mind the placement of the rate indicator, so i left the yellow and red leds alone and drilled a hole to accept a new bypass indicator led but i can't figure out where to put the negative end (im drawing power from the jack, ran the wire across the board, luckily no ticking)
I can get it to light up all the time by attaching it to various points on the 3pdt, but not turn off with the switch. I've been banging my head on this for a bit but am out of my depth.
Thanks for reading!
I've been looking for an answer for this for a bit, so I apologize if this has already been covered in another thread that I could not seem to find. I am just beginning with pedal building so there is a lot to learn and understand!
I cut the brown wires coming from S1C to get the rate indicator LED to be always on and ready for a tap. I don't mind the placement of the rate indicator, so i left the yellow and red leds alone and drilled a hole to accept a new bypass indicator led but i can't figure out where to put the negative end (im drawing power from the jack, ran the wire across the board, luckily no ticking)
I can get it to light up all the time by attaching it to various points on the 3pdt, but not turn off with the switch. I've been banging my head on this for a bit but am out of my depth.
Thanks for reading!
Comment