Ok, so recently I had the wiring in this thread realized, which I love (thanks, @Jack_TriPpEr !):
To recap, this is the wiring I currently have:
5-way super switch-
Position 1: Bridge
Position 2: Bridge + Middle (Parallel)
Position 3: Bridge + Neck (Parallel) (no middle)
Position 4: Middle + Neck (Parallel)
Position 5: Neck
Coil Split Switch 1 splits both humbuckers
Coil Split Switch 2 selects whether the inner coils or the outer coils of the humbuckers are activated
Switch 3 puts the middle pickup out-of-phase with the humbuckers
QUESTION:
1. Is it possible to substitute a 3-way on-on-on switch for "Coil Split Switch 1," where the third position puts both humbuckers in parallel with themselves?
2. Is it possible to use "Switch 3" - only active in "Super switch Position 3" - to toggle between: 1. Bridge + Neck (Parallel); and 2. Middle Pickup alone?
To recap, this is the wiring I currently have:
5-way super switch-
Position 1: Bridge
Position 2: Bridge + Middle (Parallel)
Position 3: Bridge + Neck (Parallel) (no middle)
Position 4: Middle + Neck (Parallel)
Position 5: Neck
Coil Split Switch 1 splits both humbuckers
Coil Split Switch 2 selects whether the inner coils or the outer coils of the humbuckers are activated
Switch 3 puts the middle pickup out-of-phase with the humbuckers
QUESTION:
1. Is it possible to substitute a 3-way on-on-on switch for "Coil Split Switch 1," where the third position puts both humbuckers in parallel with themselves?
2. Is it possible to use "Switch 3" - only active in "Super switch Position 3" - to toggle between: 1. Bridge + Neck (Parallel); and 2. Middle Pickup alone?
Comment