banner

Announcement

Collapse
No announcement yet.

How to ID bar magnet?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Re: How to ID bar magnet?

    Last question: they look like they're from a 7-string. Could I use a rotary tool (or something else?) to cut them to 6-string length? Or would that somehow screw up the magnetism?

    They're cheap enough I can get new, but I don't mind a little handiwork.

    Comment


    • #17
      Re: How to ID bar magnet?

      magnets dont usually like to be cut once charged. how long are they? 2.5" is typical but there have been slightly longer mags used in 6 strings too.

      ive heard a3 rods are stronger than a2 rods of the same size but dont have actual evidence of this.

      Comment


      • #18
        Re: How to ID bar magnet?

        Originally posted by Chistopher View Post
        This is the equivalent of saying not to measure how cold something is because temperature is measured in heat.
        Not quite.
        Originally Posted by IanBallard
        Rule of thumb... the more pot you have, the better your tone.

        Comment

        Working...
        X