Verne Andru
New member
I'm putting an EMG-89 in a very small guitar and got a triple shot to use for switching.
I would like to wire one of the sliders to switch the 89 from humbucker to single-coil, and the other to switch a bypass so the signal goes directly to the output jack from the pickup, avoiding the volume and tone controls.
I'm familiar with wiring, etc. but could use a bit of guidance on how the TS is put together.
It appears from the bottom to be 2 x DPDT sliding switches that have some dedicated wiring via the attached PCB. Can anyone confirm this? If they are, I don't have an issue with cutting traces on the PCB to make the switches do what I need. Just need to know if there is anything funky going on in there I should be aware of.
Thanks.
I would like to wire one of the sliders to switch the 89 from humbucker to single-coil, and the other to switch a bypass so the signal goes directly to the output jack from the pickup, avoiding the volume and tone controls.
I'm familiar with wiring, etc. but could use a bit of guidance on how the TS is put together.
It appears from the bottom to be 2 x DPDT sliding switches that have some dedicated wiring via the attached PCB. Can anyone confirm this? If they are, I don't have an issue with cutting traces on the PCB to make the switches do what I need. Just need to know if there is anything funky going on in there I should be aware of.
Thanks.