black covers for SSL-6 custom?

C

cbope

New member
Probably gonna replace the Duncan Designed SC-101 singles (neck and middle) in my Jackson DK2 with these pups. I've got a PATB-3 in the bridge. Two questions:

1. I've noticed that they only seem to be available with white covers. Where can I find black covers? Or can I use the black covers from my SC-101's?

2. What about a reverse wound for the middle position? I haven't seen these listed anywhere.

My DK2 has a normal 5-way blade switch and I don't plan any special wiring or configuration. This is mainly just an upgrade from the designed pups to real Duncans.
 
Re: black covers for SSL-6 custom?

the black covers you have should work fine

you can get rw/rp but few places will have them in stock, so they will probably need to be ordered
 
Re: black covers for SSL-6 custom?

1.) I have black SD single coil covers available through my website if you need them.

2.) As Jeremy said, they are available RW/RP but there is an upcharge for this service of around $10.00. I don't keep them in stock but I'd be happy to order one in for you.
 
Re: black covers for SSL-6 custom?

I got my SSL-2 rw/rp and SSL-6 pups today. On the box, there is a notice to only use covers that are made in USA. It says import covers are made to metric specs and can damage the pups. I haven't yet removed my old SC-101's to check for potential problems in re-using the covers. Luckily I will be able to compare the white cover that came with the SSL-6 with the SC-101 covers, but it would be nice to know before I take the old pups out, in case I need to order some new black covers.

Anyone?
 
Re: black covers for SSL-6 custom?

Went for it and changed the pups. The Duncan Designed covers fit ok. I will try to find some real SD covers though, there is definitely a quality difference even in the covers.
 
Re: black covers for SSL-6 custom?

as long as the cover fits the pole spacing then i wouldnt worry about it. they dont change tone
 
You must log in or register to reply here.
Back
Top